This is a ride plate that holds the bow of your Thrasher down at top speed. These attached very easily from the outside of the boat with a single screw. This upgrade will make your hull plane out very quickly, keep your pump in the water and hooked up more often for increased speed and handling. Improved cornering with reduced slide is also achieved with this simple option.
2 pack - Stock tail bushing for all Thrasher versions
Stock wear ring for Thrasher V1 and V2
Compatable with V1 and V2 Thrasher Jet Boats, these extremely rugged protectors are made from 18 gauge stainless steel sheet. These parts will take a beating and will allow you to run your Thrasher in shallow water over rock and protect your jet drive during even the hardest bashing sessions.
Stock servo motor for Thrasher V1 and V2. Includes horn and stainless steel mounting screws.
This drive shaft seal is located between the pump body and the motor mount to significantly reduce the flow of water into the hull. One seal is used per boat. Includes two seals.