Stock lid pin for all versions of Thrasher RC Jet Boats
Resettable BEC Fuse for V1, V2, and V3 Thrashers
Use this fuse in line between your ESC and your Receiver to protect your electronics against damage when an issue occurs. We recomend that a fuse always be installed and that you never run your Thrasher unprotected.
Addition hull vent kit
This upgrade adds an additional vent to your hull allowing it to self right faster and more reliably. The kit is quick to install but will require you to drill a hole and insert a port using a soldering iron. A 5mm drill and a soldering iron is required.
Graphics KitS for V1, V2 and V3 Thrasher Jet Boats
Our graphics kits are made from the highest quality printed vinyl. With air release technology and installation friendly adhesive, these are the easiest decals you will ever install. These kits will install on V1, V2 and V3 Thrasher Jet Boats.
Full size servo kit with Billet Aluminum horn and quick trim adjust system
This is a heavy duty steering option for Thrasher V1 and V2. In this kit you will receive a full size waterproof servo, an adapter plate for mounting this servo in your Thrasher, and a complete steering linkage with boot, servo arm, and quick trim adjust system. This kit not only makes your Thrasher steering system more rugged and waterproof, but it makes trim adjustments much easier with acces to a set screw for trim adjustment from the top of the boat without moving the servo moutn plate.
Full size servo adaptor kit
This kit comes with all that you will need to install your full size servo into a Thrasher V1 or V2. This kit comes with an adaptor plate, a steering rod, a quick trim adjusts system and a billet aluminum horn. Because servos can vary in mounting dimensions, please check the drawing in the attached image to make sure that your servo will fit before making your purchase. Another consideration is the height that your servo will fit the horn above the mounting plate as well as how deep your servo body will sit below the mounting plate. This plate is designed for the servo horn to sit on a spline that has a top surface that is 20 mm above the servo mount surface of the plate and it is designed for a servo that is no deeper than 27 mm from the mounting surface to the bottom of the servo. Please view our how to installation video prior to installation.
Thrasher V1, V2, and V3 Lid Captive Screw
Captive screw for Thrasher lids - Fits all Thrasher Lids.
Bilge Check Valve
Check valve for stock Thrasher bilge systems
Automatic Power Bilge System Thrasher V2
The automatic power bilge system is designed to intall into your V1/V2 jet boat as per the video below. This system allows you to run your Thrasher without needing to be concerned with whether or not the bilge should be turned on our off because it includes an onboard controller that does all of this for you. This is a one of a kind advancement for RC boating. Designed to bolt on and plug into all Thrasher V1/V2 Jet Boats ( drilling the hull is required ). This bilge pump system utilizes a unique waterproof control module that senses if your RC boat is rightside up or upside down before it will trigger the bilge pump if water is sensed inside the boat. All controls, brackets, and wiring is included. There is no wiring or soldering required. This is a bolt on and plug in system. No additional channel is required. This is a fully automatic system.
The advantage of this system will remove water from your Thasher quickly, eliminating the need to bring your Thrasher to shore to empty it out after a self right event or any other event that fills the hull with water.
The tradeoff of this system is that it adds 56 grams to your Thrasher
Check out this demonstration video:
How to install in a Thrasher V1/V2:
Intake grate - set of stainless steel rods
Intake grate - set of stainless steel rods for Thrasher V1 and V2