This kit comes with all that you will need to install your full size servo into a Thrasher V1 or V2. This kit comes with an adaptor plate, a steering rod, a quick trim adjusts system and a billet aluminum horn. Because servos can vary in mounting dimensions, please check the drawing in the attached image to make sure that your servo will fit before making your purchase. Another consideration is the height that your servo will fit the horn above the mounting plate as well as how deep your servo body will sit below the mounting plate. This plate is designed for the servo horn to sit on a spline that has a top surface that is 20 mm above the servo mount surface of the plate and it is designed for a servo that is no deeper than 27 mm from the mounting surface to the bottom of the servo. If you have a favorite servo that will not mount using this mounting plate, please send me an e-mail at firstname.lastname@example.org and I will consider adding a suitable plate to our offering. Please view our how to installation video prior to installation.
2 pack - Stock tail bushing for all Thrasher versions
Stock wear ring for Thrasher and Thrasher XT
Compatable with V1 and V2 Thrasher Jet Boats, these extremely rugged protectors are made from 18 gauge stainless steel sheet. These parts will take a beating and will allow you to run your Thrasher in shallow water over rock and protect your jet drive during even the hardest bashing sessions.
Stock servo motor for Thrasher and Thrasher XT. Includes horn and stainless steel mounting screws.
This drive shaft seal is located between the pump body and the motor mount to significantly reduce the flow of water into the hull. One seal is used per boat. Includes two seals.